Search results

In-situ aluminum metal matrix composites (AMMC) have taken over the use of ex-situ AMMC due to the generation of finer and thermodynamically stable intermetallic compounds. However, conventional processing routes pose inevitable defects like porosity and agglomeration of particles. This paper aims to study current state of progress in in-situ AMMC fabricated by Friction Stir Processing.

Friction stir processing (FSP) has successfully evolved to be a favorable in-situ composite manufacturing technique. The dynamics of the process account for a higher plastic strain of 35 and a strain rate of 75 per second. These processing conditions are responsible for grain evolution from rolled grain → dislocation walls and dislocation tangles → subgrains → dislocation multiplication → new grains. Working of matrix and reinforcement under ultra-high strain rate and shorter exposure time to high temperatures produce ultra-fine grains. Do the grain evolution modes include subgrain boundaries → subgrain boundaries and high angle grain boundaries → high angle grain boundaries.

Further, the increased strain and strain rate can shave and disrupt the oxide layer on the surface of particles and enhance wettability between the constituents. The frictional heat generated by tool and workpiece interaction is sufficient enough to raise the temperature to facilitate the exothermic reaction between the constituents. The heat released during the exothermic reaction can even raise the temperature and accelerate the reaction kinetics. In addition, heat release may cause local melting of the matrix material which helps to form strong interfacial bonds.

This article critically reviews the state of the art in the fabrication of in-situ AMMC through FSP. Further, FSP as a primary process and post-processing technique in the synthesis of in-situ AMMC are also dealt with.

Material extrusion (MEX) 3D printers suffer from an intrinsic limitation of small size of the prints due to its restricted bed dimension. On the other hand, friction stir spot welding (FSSW) is gaining wide interest from automobile, airplane, off-road equipment manufacturers and even consumer electronics. This paper aims to explore the possibility of FSSW on Acrylonitrile Butadiene Styrene/Polylactic acid 3D-printed components to overcome the bed size limitation of MEX 3D printers.

Four different tool geometries (tapered cylindrical pin with/without concavity, pinless with/without concavity) were used to produce the joints. Three critical process parameters related to FSSW (tool rotational speed, plunge depth and dwell time) and two related to 3D printing (material combination and infill percentages) were investigated and optimized using the Taguchi L27 design of experiments. The influence of each welding parameter on the shear strength was evaluated by analysis of variance.

Results revealed that the infill percentage, a 3D printing parameter, had the maximum effect on the joint strength. The joints displayed pull nugget, cross nugget and substrate failure morphologies. The outcome resulted in the joint efficiency reaching up to 100.3%, better than that obtained by other competitive processes for 3D-printed thermoplastics. The results, when applied to weld a UAV wing, showed good strength and integrity. Further, grafting the joints with nylon micro-particles was also investigated, resulting in a detrimental effect on the strength.

To the best of the authors’ knowledge, this is the first study to demonstrate that the welding of dissimilar 3D-printed thermoplastics with/without microparticles is possible by FSSW, whilst the process parameters have a considerable consequence on the bond strength.